SICK RFH5 - Page 43

Index dec
(hex)
Name Format
(Offset)
Lenght Access
1)
Default
Value
Value / Range Remark [Unit]
4 (0x04) C/Q1 Polarity Bit (64) 8 Bit rw 0 0 = Output "close" if
condition = true
1 = Output "open" if
condition = true
5 (0x05) C/Q1 & Q2 Output
Hold Time
Bit (56) 8 Bit rw 0 0 = Output hold
time = 0 ms
1 = 100 ms
2 = 200 ms
3 = 500 ms
4 = 1000 ms
5 = 2000 ms
6 (0x06) Evaluation condition
Q2
Bit (48) 8 Bit rw 0 0 = Transponder
Presence
1 = Compare data
2 = Alarm 1
3 = Alarm 2
4 = SIO deactivated
7 (0x06) Memory address for
compare data mode
(Q2)
Bit (40) 8 Bit rw 0 Transponder memory
block adress for "Com‐
pare Data"
8 (0x08) Q2 comparison data
for compare data
mode
Bit (8) 32 Bit rw 0 Reference data value
stored in RWM mem‐
ory to be compared to
transponder data
9 (0x09) Q2 Polarity Bit (0) 8 Bit rw 0 0 = Output "close" if
condition = true
1 = Output "open" if
condition = true
1)
ro = read only, wo = write only, rw = read/write
2)
Subindex access not supported
RF Configuration
With RF configuration or the RSSI threshold, the detection range (working range) of the
device can be limited (reduced).
The RSSI value specifies the signal strength of the signal received by the device.
•
Maximum value: 0x07
•
Minimum value: 0x00
NOTE
The device also reads transponders with a RSSI value of 0x00.
The RRSI threshold specifies the minimal RSSI value that must be achieved so that a
transponder is output. If the RSSI value is below the RSSI threshold, the device does
not output transponder data into the process data.
Index dec
(hex)
Name Format
(Offset)
Lenght Access
1)
Default
Value
Value /
Range
Remark [Unit]
66 (0x42) RF configuration Record
2)
4 Byte rw RF configuration
OPERATION 8
8025309/1KDE/2023-12-19 | SICK O P E R A T I N G I N S T R U C T I O N S | RFH5xx
43
Subject to change without notice