Siebeck FRT-A-SB Series

Need help?

Do you have a question about the Siebeck FRT-A-SB Series and is the answer not in the manual?

Summary

Hazard Warnings and Manual Comprehension

Safety Precautions for Installation and Repair

Emphasizes qualified personnel and original parts for safety.

Machine Warranty Information

Warranty Validity and Original Parts Requirement

Warranty is void if non-original parts or modifications are used.

Essential Safety Procedures

Startup, Reference Run, and Power Disconnection

Covers initial startup checks, reference run, and disconnecting power for maintenance.

Safety Instructions for Transportation

Component Disconnection and Conveyor Stability

Steps to disconnect components and warning about conveyor top-heaviness.

Set-up and Commissioning - Mechanics

Erecting, Securing, and Hood Safety Checks

Erecting the machine, checking hood safety mechanisms, and warnings.

Set-up and Commissioning - Systems

Machine Clearance, Electrical System, and Safety Sensor Function

Covers machine clearance, electrical setup, and safety sensor operation.

Fitting the Foot Pedal

Foot Pedal Installation Steps and Checks

Steps for installing the foot pedal, including panel removal and initial checks.

Inserting the String

String Preparation and Routing Through Components

Steps for preparing the string, routing it through guides, brakes, and the aggregate.

Inserting the String (F Take-up Lever)

Specific String Insertion Procedure for F Take-up Lever

Detailed steps for string insertion tailored to the F take-up lever model.

Operating Controls and Display

Identification of Control Cabinet and Hood Components

Describes controls located on the control cabinet and machine hood.

Understanding the Display and Operating Screen

Explains the function and layout of the machine's display screen.

Cleaning and Maintenance - General

Mandatory Daily Cleaning and Protective Measures

Emphasizes thorough daily cleaning and use of protective clothing.

Tying Machine Cleaning and Bobbin Removal

Cleaning and Maintenance - Agent Restrictions

Prohibited Cleaning Agents and Recommended Procedures

Cleaning the Conveyor Belts

Conveyor Removal, Installation, and Safety Warnings

Conveyor Belt Cleaning Process

Cleaning and Maintenance - Intermediate Steps

Intermediate Cleaning and Post-Cleaning Lubrication

Tensioning and Adjusting Conveyor Belts

Belt Tension Adjustment and Drift Correction

Maintenance Procedures - Lubrication and Checks

Importance of Lubrication and Approved Products

Specific Lubrication Points and Component Checks

Maintenance Procedures - Post-Checks and Tests

Post-Maintenance Checks, Safety Verifications, and Test Runs

Stripper Setting and Adjustment

Side, Height, and Pressure Adjustments for Stripper

Checking Zero Position on Knotting Aggregate

Definition of Correct Zero Position

Adjusting Zero Position on Knotting Aggregate

Lever Adjustment and Saving the Zero Position

The Story of Knots - Common Issues

Identifying and Resolving Knot Pattern Problems

The Story of Knots - Knot Quality

Addressing Loop Lengths, Torn Ends, and Perfect Knot Definition

Faults and Their Causes

Troubleshooting Threading, String, and Twine Button Issues

Maintenance Instructions - Aggregate and Ring

Maintenance Schedules for Knotting Aggregate and Ring

Maintenance Instructions - Systems and Belts

Checks for Hood, Electrical, Pneumatic, and Belt Systems

Troubleshooting Guide

Common Faults and Recommended Remedies

Residual Risks and Incorrect Operation

Warnings for Jog Mode and Crushing Hazards

Residual Risks and Operational Safety

Protective Device Integrity and Cleaning Gap Risks

Residual Risks - Mechanical and Thermal Hazards

Crushing Hazards and Thermal Risks from Motors

Risk of Cuts - Knife Handling Safety

Safe Knife Installation, Removal, and Handling Precautions