© Arc Euro Trade Ltd, England 2012
© Arc Euro Trade Ltd, England 2012
- 18 -
Always follow the correct Start-Up Procedure
1. Check everything is switched off -
• Mains power off
• Press Emergency stop switch (C) to turn off
• Forward/reverse (B) to the centre position (off)
• Speed control knob (A) turned fully anti-clockwise.
2. Switch on at the mains
3. Close the chuck guard
4. Slide back the emergency stop switch to release
5. Select forward or reverse
6. Slowly increase the speed by turning knob A
If the Fault LED (D) lights up and the machine will not
run, check that the correct starting sequence has been
followed.
Running the spindle for the fi rst time:
1. Follow the Start-Up procedure with low gear selected and the motor running
forwards.
2. Run the machine at a low RPM. The machine should run smoothly with minimal
noise and vibration. If not turn off the machine and investigate the cause of the
problem.
3. Slowly increase the speed and run for 10 minutes at a high RPM.
4. Stop the machine and repeat steps 1-3 above in high gear.
5. Stop the machine and repeat steps 1-4 above in reverse.
This procedure will help to bed the motor brushes in and minimise arcing on the
motor commutator. It will also help bed in the taper roller bearings if you fi tted them.
To Previous Page
Loading...