Siemens BE525LMS0H - Overview of the basic settings; Changing basic settings; Changing the signal duration; Setting the time

Basic settings en
13
Cooking food with the automatic programmes
1.
Weigh the food.
You require the weight in order to set the pro-
gramme.
2.
Place the food on microwave-safe cookware and
cover with a lid.
3.
Add the volume of water in accordance with the
manufacturer's instructions on the packaging.
4.
Set the programme. →Page11
5.
Once the programme has finished, stir the food
again.
6.
The food should be left to stand for an additional 5
to 10minutes until it reaches a uniform temperature.
The cooking results are dependent on the food
quality and consistency of the food.
10.6 Combi-cooking programme
With the combi cooking programme, you combine microwave and grill.
Programme Food Cookware Weight range inkg
P08 Frozen bake, up to 3cm deep Open 0.40–0.90
Cooking food using the combi cooking
programme
1.
Take the food out of its packaging.
2.
Weigh the food.
You require the weight in order to set the pro-
gramme.
3.
Place the food in microwave-safe, heat-resistant
cookware that is not too big.
4.
Set the programme. →Page11
5.
Once the programme has finished, leave the food to
rest for another 5–10 minutes to allow the temperat-
ure to even out.
11 Basic settings
You can configure the appliance to meet your needs.
11.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Setting Selection Meaning
Button tone
1
Switch on the button tone.
Button tone Switch off the button tone.
Note:The button tone remains active for and ⁠.
Demo mode ⁠ Activate or deactivate demo mode.
Note:The appliance is switched off. You can use the buttons and the display,
the buttons do not work. Demo mode is mainly useful for dealers.
1
Factory setting (may vary according to model)
11.2 Changing basic settings
Requirement:The appliance is switched off.
1.
Press and hold and for a few seconds.
a The display shows the first basic setting.
2.
Press ⁠.
a The current value flashes on the display.
3.
Use the settings area to set the required value.
4.
Press ⁠.
a The appliance implements the setting.
5.
Press ⁠.
Tip:The setting can be changed at any time.
11.3 Changing the signal duration
When your appliance is switched off, you hear an aud-
ible signal. You can change the duration of the signal.
▶
Press and hold for approx. sixseconds.
a The signal duration switches between short and
long.
a The appliance applies the signal duration and dis-
plays the time.
11.4 Setting the time
Note:After connecting the appliance to the power or
following a power cut, a signal sounds and several
zeros are shown on the display. It may take a few
seconds until a signal sounds and you can set the
time.