Siemens BE555LMS0 - Troubleshooting; Identifying and Resolving Malfunctions

en Troubleshooting
14
▶
If the power cord of this appliance is damaged, it
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
11.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not working. The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Malfunction
1.
Switch off the fuse in the fuse box.
2.
Switch the fuse back on after approx. 10seconds.
a If the fault was a one-off, the message disappears.
3.
If the message appears again, call the after-sales service. Please specify the
exact error message when calling.
→"Customer Service", Page15
Door is not fully closed.
▶
Check whether food remains or foreign material are trapped in the door.
Food takes longer than usual to
heat up.
The microwave power setting is set too low.
▶
Set a higher microwave power setting. →Page9
You have placed a larger amount of food than normal in the appliance.
▶
Set a longer cooking time.
You need double the time when you have double the amount.
The food is colder than usual.
▶
Turn or stir the food from time to time during cooking.
Turntable grates or grinds. There is dirt or foreign objects in the area of the turntable drive.
▶
Clean the roller ring and recess in the cooking compartment.
Microwave mode is cancelled. Appliance has a fault.
▶
If this fault recurs, call the after-sales service.
The appliance is not in operation.
A cooking time is shown in the
display.
The settings area has been activated accidentally.
▶
Press ⁠.
was not pressed after the setting was implemented.
▶
Press or delete the setting by pressing ⁠.
Three zeros flash on the display. There has been a power cut.
▶
Reset the time.
→"Initial configuration", Page8
An is shown on the display. Demo mode is activated.
The message appears on the
display.
Fault in the automatic door opening system.
1.
Switch off the appliance.
2.
Wait for 10minutes.
3.
Switch the appliance on again.
▶
If this fault recurs, call the after-sales service.