Siemens BF520LMR0 - Tall Unit Installation Dimensions; Preparing the Tall Unit; Preparing the Appliance

Installation instructions en
17
12.8 Preparing the tall unit
1.
Determine the wall thickness of the unit.
An x-value is assigned to the wall thickness.
2.
Note:The x-value corresponds to the distance
between the lower edge of the connection plate and
the bottom of the fitted unit.
Screw the connection plate tightly to the tall unit.
When doing so, observe the x-value that was de-
termined.
12.9 Preparing the appliance
If you install your appliance in a tall unit, you must pre-
pare the appliance.
1.
Remove the middle screw on the base of the mi-
crowave.
2.
Remove the cover at the base of the microwave.
3.
Screw the middle screw tightly on the base of the
microwave.
4.
Loosen the two outer screws on the microwave
base.
5.
Secure the built-in frame on the microwave base
with the two outer screws.
6.
Secure the four supporting feet to the base of the
microwave.