Siemens CM778GNB1B - Page 19

Ventilation function "Crisp Finish" en
19
11.4 Setting added microwave
Note:
Note the correct way to operate the microwave:
¡ →"Safety", Page2
¡ →"Preventing material damage", Page7
¡ →"Microwave output settings", Page12
¡ →"Cookware and accessories with microwave",
Page17
Requirement:Observe the information about the re-
spective operating mode.
→"Setting options with the microwave", Page18
1.
Press the operating mode that you require.
2.
Implement the settings for the operating mode, e.g.
type of heating and temperature.
3.
Press "Added microwave"
⁠.
4.
Press the required microwave output setting.
5.
Press "Cooking time" and set the cooking time.
6.
Use "Start" to start the operation.
a The appliance starts to heat and the time counts
down.
a Once the cooking time has elapsed, a signal tone
sounds. A notification appears on the display con-
firming that the operation has finished.
7.
Once the cooking time has elapsed:
‒ If required, you can select other settings and re-
start the operation.
‒ When the food is ready, use to switch the ap-
pliance off.
Changing added microwave
You can change or deactivate the added microwave at
any time.
1.
Press the microwave output setting.
2.
Change or deactivate the microwave output setting.
3.
Press "Apply".
12 Ventilation function "Crisp Finish"
The ventilation function "Crisp Finish"
extracts mois-
ture from the cooking compartment so that your meal
will be more crispy.
Hot steam that may escape when the appliance door is
opened is reduced.
12.1 Suitable types of heating with the
ventilation function
Only certain types of heating are suitable for the ventil-
ation function.
You can use the ventilation function for the following
types of heating:
¡ 4Dhot air
¡ Top/bottom heating
¡ Intensive heat
¡ Pizza setting
¡ Circulated air grilling
12.2 Setting the ventilation function
You can activate the ventilation function at any time,
even after the start of the operation.
1.
Set a suitable type of heating and a temperature.
If required, you can select other settings and com-
bine with the ventilation function.
2.
Press "Crisp Finish".
a "On" is in the tile.
3.
Press "Start" to start the operation.
a The appliance starts heating.
a The setting values are shown on the display.
4.
When the food is ready, use
to switch the appli-
ance off.
Note:Amplified fan noises can be heard while the ap-
pliance is in operation.
Cancelling the ventilation function
You can switch off the ventilation function at any time.
▶
Press "Crisp Finish"
⁠.
a For "Crisp Finish" , "Off" appears on the display.
a The operation continues without the ventilation func-
tion.
13 Meat probe
Cook with precision by inserting the meat probe
into
the food and setting a core temperature on the appli-
ance. The meat probe measures the core temperature
inside the food. Once the set core temperature has
been reached in the food, the appliance automatically
stops heating.
13.1 Suitable types of heating with the meat
probe
Only certain types of heating are suitable for use with
the meat probe.
You can use the meat probe with the following types of
heating:
¡ 4Dhot air
¡ Top/bottom heating
¡ Bottom heat
¡ Top/bottom heat gentle
¡ Hot air gentle
¡ Circulated air grilling
¡ Pizza setting
¡ Keeping warm
¡ Intensive heat
¡ Slow cooking