Page EN-10 XRS-5 Series Transducers – OPERATION MANUAL 7ML19985QT81
XRS-5C Installation Diagram
CERTIFIED JUNCTION BOX
XRS-5C
TRANSDUCER
XRS-5C
TRANSDUCER
MILLTRONI CS
CONTROLLER
MILLTRONI CS
CONTROLLER
CERTIFIED
CONDUIT
SEAL
FITTING
CERTIFIED
CONDUIT
COUPLING
CERTIFIED
CONDUIT
COUPLI NG
CERTI FIED
CONDUI T
SEAL
FITTING
METAL CONDUI T
METAL CONDUIT
1=1
11
R. HARE
R. CLYSDALE
NONE
S. NGUYEN
XRS-5C TRANSDUCER
INTERCONNECTION DIAGRAM
FOR HAZARDOUS LOCATIONS
2365016200
23650162
0
RPC
SN
26/00
SEPT
0
FOR CONSTRUCTI ON
NON-HAZARDOUS LOCATION
(SAFE)
FACTORY
INSTALLED
STAINLESS STEEL
COUPLER
(SEE NOTE 1)
FACTORY
INSTALLED
STAINLESS STEEL
COUPLER
(SEE NOTE 1)
NOTES:
1. FOR CONDUIT MOUNTING: APPLY TIGHTENING TORQUE TO THE
STAINLESS STEEL COUPLER ONLY, AND NOT TO THE TRANSDUCER
HOUSING, OTHERWISE IT MAY IMPAIR SUITABLY FOR USE IN
HAZARDOUS LOCATIONS.
2. DO NOT SECURE TRANSDUCER HOUSING TO STRUCTURAL SUPPORTS
WITH METAL CLAMPING DEVICES.
3. INSTALLATION SHALL BE DONE IN ACCORDANCE WITH CANADI AN
ELECTRICAL CODE PART 1 REQUIREMENTS.
4. ASSURE ELECTRICAL CONTINUITY AT COUPLING / CONDUIT
THREADED JOINT.
HAZARDOUS LOCATION
CLASS I, DIV 1, GROUPS A, B, C, D
CLASS II, DIV 1, GROUPS E, F, G
To Next Page
Loading...
