Need help?Do you have a question about the Siemens XPS10 and is the answer not in the manual?
General| Category | Transducer |
|---|---|
| Manufacturer | Siemens |
| Model | XPS10 |
| Type | Pressure Transducer |
| Applications | Industrial pressure measurement |
| Pressure Range | 0...600 bar (depending on model) |
| Output | 4...20 mA |
| Accuracy | ±0.5% FS |
| Electrical Connection | M12 connector |
| Process Connection | 1/4 NPT |
| Operating Temperature | -40...+85 °C |
Discusses using transducers in hazardous areas and specific requirements for XPS 10 F and XPS 15 F.
Details measurement range, frequency, beam angle, environmental, construction, supply source, weight, separation, and approvals.
Details measurement range, frequency, beam angle, environmental, construction, supply source, weight, separation, and approvals.
Provides diagrams and dimensions for various mounting options of the XPS 10 F transducer.
Provides diagrams and dimensions for various mounting options of the XPS 15 F transducer.
General advice on handling, positioning, aiming, and securing transducers during installation.
Specific guidance and diagrams for mounting transducers in solids applications, including aiming.
Diagrams and notes for mounting transducers in various liquid application configurations like flexible conduit, submersible, and bracket.
Details blind flange and flanged mounting methods, including notes on gasket and bolt tightening.
Advice on cable routing, conduit use, sealing, and avoiding electrical noise for optimal signal integrity.
Illustrates direct wiring from transducer to controller in hazardous and non-hazardous locations.
Explains 2-wire extension and coaxial cable methods for transducer signal transmission.
Covers specific liquid applications like Stilling Well/OCM, showing transducer setup.
Details the use of submergence shields in flooding environments and their interaction with the transceiver.
Guidance on standpipe dimensions, transducer placement, and considerations for measurement reliability.
Explains principles for volume measurement in tanks, including beam angle effects and calibration.
Examples of transducer deployment in water/wastewater systems like pump control and sewage lift.
Best practices for aiming and positioning transducers in solids handling for accurate level measurement.
Covers specific scenarios such as storage bins with agitators, focusing on transducer placement.
Specific mounting advice for transducers in wood chip dryers, considering material slope and infeed.
Detailed diagram illustrating the interconnection of XPS 10 F transducers for hazardous and non-hazardous locations.
To Next Page