“Power on/off” and
residual heat
indicator
Every cooking zone is fitted with a “power on/off” and
residual heat indicator which comes on when the
flame on the corresponding burner is ignited.
The residual heat indicator continues to flash after
the cooking zone has been switched provided the
hotplate is still hot enough to be dangerous when
touched.
The residual heat indicator goes out when the
hotplate has cooled sufficiently.
Power levels
The progressive controls can be used to control
the power needed, from minimum to maximum
power.
Setting
Large flame
Economy
flame
Control off
Maximum capacity or
aperture and electricity
on
Minimum capacity or
aperture
For dual double flame burners, the inner and outer
flames can be controlled separately.
The available power levels are as follows:
Inner and outer flame on full power.
Outer flame on minimum, inner flame on full power.
Inner flame on full power.
Inner flame on minimum.
8
To Next Page