EasyManua.ls Logo

Siemens Gigaset C590 - Display in Idle Status

Siemens Gigaset C590
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
First steps
Gigaset C590/C595 / USA-CAN engl / A31008-M2101-R301-1-3S19 / starting.fm / 19.04.2010
Version 4, 16.09.2005
Initial charging and discharging of the batteries
The correct charge level can only display if the batteries are first fully charged and
discharged.
¤ Place the handset in the base/charging cradle
for 10 hours.
¤ Then remove the handset
from the base/charging cra-
dle and do not replace it
until the batteries are fully
discharged.
10 h
Please note
u After the first battery charge and discharge you may replace your handset in
the base/charging cradle after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical
reasons.

Other manuals for Siemens Gigaset C590

Related product manuals