en
37
Fault Possible cause Remedial action
Temperature differs greatly
from the set value.
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
A warning signal sounds.
Temperature display flashes.
Fig. "/2
Fault - the freezer section is
too warm!
Frozen food is at risk.
To switch off the warning signal, press
temperature setting button Fig. "/4.
Appliance is open. Close the appliance.
Ventilation openings are
covered up.
Ensure that there is adequate ventilation.
Too much food was placed in
the freezer at once.
Do not exceed the freezing capacity.
When the fault has been eliminated, the
temperature display stops flashing.
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
The evaporator (refrigeration
generator) in the NoFrost
system is covered in thick ice
and can no
longer be defrosted fully
automatically.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well
and store in a cool location.
Switch off the appliance and move it away
from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins
to run into the evaporation pan,
at the rear of the appliance. Fig. *
To prevent the evaporation pan
from overflowing in this case,
mop up the condensation with a sponge.
The evaporator is defrosted when the water
stops running into the evaporation pan. Clean
the interior. Switch the appliance
back on again.
Appliance is not cooling,
temperature display and light
are lit.
Showroom mode is
switched on.
Start appliance self-test (see chapter
“Appliance self-test”).
When the programme has ended,
the appliance switches over to normal
operation.
To Next Page
Loading...
