operation en
19
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
1. Electrically connect the appliance.
→Page16
Note:If the appliance has been
previously switched off using the
control panel, press and hold
for 15 seconds.
a The appliance begins to cool.
a A warning tone sounds, the tem-
perature display (freezer compart-
ment) flashes and lights up red
because the freezer compartment
is still too warm.
2. Switch off the warning tone using
.
a goes out as soon as the set
temperature has been reached.
3. Set the required temperature.
→Page19
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and side panels of
thehousing heat up occasionally.
This prevents condensation from
forming.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶ Press and hold for 15seconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
1. Select the refrigerator compart-
ment using .
2. Press / repeatedly until the
temperature display (refrigerator
compartment) shows the required
temperature.
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→Page19
The recommended temperature in
the refrigerator compartment is
4°C.
Setting the storage container
temperature
1. To reduce the temperature, slide
the temperature controller in the
direction.
2. To increase the temperature, slide
the temperature controller in the
direction.
→Fig.
9
Setting the freezer compartment
temperature
1. Select the freezer compartment
with .
2. Press / repeatedly until the
temperature display (freezer com-
partment) shows the required tem-
perature.
The recommended temperature in
the freezer compartment is
−18°C.
To Next Page
Loading...
