Siemens iQ500 KI81RAF30M - Basic operation; Setting the temperature

operation en
35
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
1. Press .
a The appliance begins to cool.
2. Set the required temperature.
→Page35
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶ Press .
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
▶ Press / repeatedly until the
temperature display shows the re-
quired temperature.
The recommended temperature in
the refrigerator compartment is
4°C.
→""OK" sticker", Page36
8 Additional functions
8.1 Super cooling
With Super cooling, the refrigerator
compartment cools as cold as pos-
sible.
Switch on Super cooling before pla-
cing large quantities of food.
Note:When Super cooling is
switched on, increased noise may
occur.
Switching on Super cooling
▶ Press .
a lights up.
Note:After approx. 15hours, the ap-
pliance switches to normal operation.
Switching off Super cooling
▶ Press .
a The previously set temperature is
displayed.
9 Alarm
9.1 Door alarm
If the appliance door is open for a
while, the door alarm switches on.
A warning tone sounds.
Switching off the door alarm
▶ Close the appliance door or press
.
a The warning tone is switched off.