Siemens LR96CBS20 User Manual

en Before using for the first time
6
Tip:Align the remote control as precisely as possible
to the infrared receiver for the LED display.
Switch the appliance on or off
Switch on automatic mode
1
Increase the fan setting
Decrease the fan setting
Switch the lighting on or off
Reduce the brightness
Increase the brightness
Switch the fan run-on on or off
Switch
HomeConnect
on or off
Reset the filter saturation indicator
1
Depending on the appliance specifications
LED display
Die LED-Anzeige zeigt eingestellte Werte und Funk-
tionen.
81 2 3 4 5 6 7
1
Fan setting 1/grease filter saturation display
2
Fan setting 2/odour filter saturation indicator
3
Fan setting 3
4
Intensive mode 1
5
Intensive mode 2
6
Automatic mode
1
/fan run-on time/interval vent-
ilation
7
HomeConnect
8
Infrared receiver
1
Depending on the appliance specifications
Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
Setting an operating mode
Your appliance is set to air extraction mode by default.
To use it in circulating-air mode, you must set the oper-
ating mode.
Note:For use in circulating-air mode, you require addi-
tional Accessories →Page14.
Requirement:The appliance is switched off.
1. Press and hold ⁠ and ⁠ for approx.three seconds.
‒ To set circulating-air mode (non-regenerable fil-
ter), press ⁠ /⁠ until LED2 lights up in the LED
display.
‒ To set circulating-air mode (non-regenerable fil-
ter), press ⁠ /⁠ until LED3 lights up in the LED
display.
‒ To convert the electronic control back to opera-
tion without the air recirculation filter, press ⁠ /⁠
until LED1 lights up on the LED display.
2. To save the setting, press and hold⁠ and⁠ for ap-
prox. three seconds.
Or wait approx. 10seconds until the setting is
saved automatically.
To cancel the setting, press⁠ .
a A signal tone sounds as soon as the selected set-
ting is saved.
Basic operation
You can find out everything you need to know about
operating your appliance here.
Switching on the appliance
Requirement:Align the remote control as precisely as
possible to the infrared receiver for the LED display.
▶
Press⁠ to switch on the appliance.
a The appliance starts at fan setting2.
a The LED for the set fan setting lights up in the LED
display.
Switching off the appliance
Switch the appliance off when you are not using it.
▶
Press ⁠ to switch the appliance off.
a The appliance switches off. Any functions currently
in progress are cancelled.
Selecting a fan setting
▶
Press ⁠ or ⁠ .
a The LED for the set fan setting lights up in the LED
display.

Siemens LR96CBS20 Specifications

General

Brand	Siemens
Model	LR96CBS20
Category	Fan
Language	English