Siemens LR97CAP21B - Cleaning the Appliance; Cleaning Controls; Saturation Indicator; Removing the Grease Filter

en Cleaning and servicing
14
Cleaning the appliance
Clean the appliance as specified.
This will ensure that the different
parts and surfaces of the appliance
are not damaged by incorrect clean-
ing or unsuitable cleaning products.
WARNING
Risk of electric shock!
An ingress of moisture can cause an
electric shock.
▶
Do not use steam- or high-pres-
sure cleaners to clean the appli-
ance.
1. Observe the information regarding
the cleaning agents.
2. Clean as follows, depending on
the surface:
‒ Clean stainless steel surfaces in
the direction of the finish using a
sponge cloth and hot soapy wa-
ter.
‒ Clean painted surfaces using a
damp sponge cloth and hot
soapy water.
‒ Clean aluminium using a soft
cloth and glass cleaner.
‒ Clean plastic using a soft cloth
and glass cleaner.
‒ Clean glass using a soft cloth
and glass cleaner.
3. Dry with a soft cloth.
4. Apply a thin layer of the stainless
steel cleaning product to stainless
steel surfaces using a soft cloth.
You can obtain stainless steel
cleaning products from the after-
sales service or the online shop.
Cleaning controls
WARNING
Risk of electric shock!
Penetrating moisture may cause an
electric shock.
▶
Do not use wet sponge cloths.
1. Observe the information regarding
the cleaning agents.
2. Clean using a damp sponge cloth
and hot soapy water.
3. Dry with a soft cloth.
Saturation indicator
The saturation indicator informs you
when the grease filters need to be
cleaned or the odour filter needs to
be replaced.
The saturation indicators for the
following LEDs are shown in the LED
display:
¡ Grease filter: The LEDs for the fan
settings 1 and 2 flash and the LED
for the saturation indicator lights
up
¡ Odour filter: The LEDs for fan set-
ting 3 and intensive mode flash
and the LED for the saturation in-
dicator lights up
After cleaning the grease filters or
after replacing the odour filter, you
should reset the saturation indicator.
→"Resetting the saturation indicator",
Page17
Removing the grease filter
WARNING
Risk of injury!
The filter cover may swing out.
▶
Open the filter cover slowly.
▶
Take hold of the filter cover after
opening until it no longer swings
out.
▶
Close the filter cover slowly.