7
Removing the fleece grease filter
: Risk of fire!
Grease deposits in the grease filter may catch fire.
Replace the grease filter at least every two months.
Never operate the appliance without the grease filter.
Note: Only use genuine replacement filters. This ensures
compliance with safety regulations and optimal performance of
the appliance.
1. Press the locks on the left and right of the filter grid.
2. Swing the filter grid down.
3. Position the filter grid at an angle and remove it.
4. Remove the wires and then remove the fleece grease filter.
5. After removing the fleece grease filter, clean the inside of the
appliance.
6. Clean the filter grid.
Fitting the fleece grease filter
1. Trim the new fleece grease filter to the required size and
place it in the filter grid.
2. Clamp the fleece grease filter in place with the wires.
3. Insert the filter grid.
Note: Make sure that the locks on the left and right of the
filter grid engage.
Changing the activated charcoal filter
(only in circulating-air mode)
In order to guarantee efficient odour filtration, the filter must be
serviced regularly.
The activated charcoal filters must be replaced at least every
4 months.
Notes
■ The activated charcoal filters are not included in the delivery.
The activated charcoal filters can be obtained from specialist
retailers, from our after-sales service or from the Online Shop.
■ The activated charcoal filters cannot be cleaned or
reactivated.
Note: Only use genuine replacement filters. This ensures
optimal performance of the appliance.
1. Remove the fleece grease filter; see the Removing the fleece
grease filter section.
2. Undo the threaded joint on the activated charcoal filter cover.
3. Remove the activated charcoal filter.
4. Insert the activated charcoal filter.
5. Screw the cover in place.
6. Fit the fleece grease filter; see the Fitting the fleece grease
filter section.
To Next Page
Loading...
Need help?
General
