Siemens RDU340 - Page 30

30 / 32
Siemens Basic Documentation CE1P3076.en
Building Technologies Index 2014-11-03
Index
A
Alarm .................................................................. 18
Automatic H/C changeover ................................. 12
Automatic heating/cooling changeover ................ 14
C
Calibrate sensor.................................................. 23
Comfort mode ....................................................... 9
Commissioning ................................................... 23
Control output ....................................................... 5
Control parameters ............................................. 20
Cooling mode ..................................................... 14
D
DC 0..10 V control signal .................................. 17
Dewpoint ............................................................ 18
Digital input ......................................................... 18
DIP switches ....................................................... 19
E
Electrical heater ...........................................11, 16
Enable electrical heater....................................... 16
Enable/disable the electrical heater ..................... 18
Energy Saving ...................................................... 9
Expert level parameters ...................................... 20
External/Return air temp. .................................... 18
External/return temperature sensor ..................... 12
F
Floor temperature limitation function ................... 13
H
Heat/cool changeover ......................................... 18
Heating mode ..................................................... 14
Housing color........................................................ 5
I
Integral action time ............................................... 8
K
Key lock ..............................................................12
M
Manually select heating or cooling mode .............14
Min / Max air flow ................................................12
Modulating output ................................................14
Mounting and installation .....................................23
Multifunctional inputs ...........................................18
O
On/off control output signals ................................17
Operating mode button ......................................... 9
Operating mode input ........................................... 9
Operating mode switchover .................................18
Operating voltage ................................................. 5
Output signal inversion ........................................13
P
Parameter setting ................................................20
Proportional band ................................................. 8
R
Remote heating/ ..................................................12
Reset parameters ................................................20
S
Sensor input ........................................................18
Service level ........................................................20
Setpoint and range limitation ...............................24
Setpoint limitation ................................................10
Single duct ......................................................... 11
Standby /Protection mode ..................................... 9
Switching differential ............................................. 8
T
Temperature out of range ....................................19
Temporary setpoint ..............................................10