Siemens RG 418 - Correcting Time and Date; How to Change Time or Date; Radio Operation and Tuning; Tuning into Stations

Instructions for use for the clock radio RG 418
Correcting the time and date
If you wish to change the time or date after having set them, press
key 4 © for at least 2 seconds.
The hour digits in the time display begin to blink and you can begin
with the adjustment as described above.
You can turn the radio on with the key 0 ©
Tune into your desired station
1. Manual station selection
with the keys I “~ and \ you can tune into the frequency of your
desired station (in 0.05 MHz steps).
1. Automatic station selection
press and hold key I “ or ~ for at least 1 second.
The appliance searches for the next station in the applicable
direction.
Automatic station-memory programming (ATS)
When using the appliance for the first time (see above), the ATS
function starts automatically and saves the 12 strongest stations in
the memory slots 1-12.
If you wish to repeat this process, turn the radio on and press and
hold keys 7 “~ and ~ for 2 seconds.
Saving the stations individually
Tune into the the station which you wish to save.
The station you have selected can be stored in one of the 12
memory slots and be call up later:
press the MEMO key ii (”“M” blinks) and select a memory slot with
keys BA.
Level P1 = slots 1-6
Level P2 = slots 7-12
The station is now saved.
Note
When you save a new station in a slot, the station previously in —
that slot is automatically erased. .
14