Siemens SAK 51 User Manual

Q
W
e
E
R
T
Y
r
U
I
O
P
}
{
q
w
Installation instructions
8AA12722 - E0 - 05/11/2003 - UK - A6E81272280
Fig. 1
Fig. 2
Fig. 3
1. Product description
The SAK 51 and SAK 52 remote keypads are used to operate
and program the central control units. The SAK 52 also has a
speaker and microphone for audio verification.
2. Supply package
The SAK 51 and SAK 52 supply packages contain the
following,
- One SAK 51 or SAK 52 remote keypad.
- One SLK 51/52 language kit with:
- installation instructions,
- operating instructions,
- one plastic front.
3. Mounting instructions
The SAK 51 and SAK 52 are designed for mounting in dry
indoor rooms. They must not be exposed to dripping or
splashing water.
Avoid touching and spilling any dust on the contact of the
keyboard.
3.1 Secure plastic front (fig. 1)
1 - Peel back the backing foil Q half way.
2 - Place the plastic front W in the recess.
3 - Stick down the plastic front in the recess whilst peeling
away the remaining backing foil.
3.2 Open housing (fig. 2)
1 - Release both locking tabs (A) and remove top section (B).
3.3Product overview (fig. 3)
- Q Mounting base,
- W Circuit board SMK 51,
- E Jumper for the microphone sensitivity,
- R Jumper for speaker volume,
- T Tamper contact,
- Y Jumper for the Buzzer
- U Cover of the Keypad,
- I Speaker
- O Mounting holes,
- P Cable inlet,
- { Cable clip,
- } Back tamper contact screw,
- q E-Bus connection,
- w Audio connection,
- e Potentiometer for LED display,
- r Potentiometer for buzzer volume.
3.4 Fit housing (fig. 3)
1 - Pull the cable through the cable inlet P .
2 - Secure the mounting base O using two screws.
3 - Use the cable clip { .
s
LCD Remote keypad
SAK 51 / 52
SLK 51/52 UK A6E80113520

Siemens SAK 51 Specifications

General

Brand	Siemens
Model	SAK 51
Category	Keypad
Language	English

Summary

Product Description and Supply

Product Description

Details the function of SAK 51/52 keypads and SAK 52's audio features for central unit operation.

Supply Package Contents

Lists items included in the SAK 51/52 supply package: keypad, language kit, and plastic front.

Mounting and Housing

Secure Plastic Front

Instructions for applying the plastic front cover to the keypad, peeling backing foil.

Open Housing

Procedure to open the keypad housing by releasing locking tabs.

Product Overview

Identifies components of the keypad housing, including base, circuit board, jumpers, and contacts.

Fit Housing

Steps to fit the housing, including cable routing, securing the base, and using cable clips.

Wiring and Configuration

E-Bus Wiring

Details E-Bus connection requirements to the central control panel and other accessories.

Audio Wiring for SAK 52

Instructions for connecting audio terminals to the central unit and speaker using twisted pair cable.

Close and Seal Housing

Procedure for closing and sealing the keypad housing after wiring.

Start-up and Addressing

Covers microphone sensitivity, speaker volume, and keypad addressing procedures.

Display Address and Test

Guides on displaying the current address and testing all LEDs and the buzzer.

Technical Data

Specifications

Provides key technical data including supply voltage, power consumption, operating temperature, and dimensions.