1-6
C7-621 / C7-621 AS-i Control Systems
C79000-G7076-C622-01
System messages display internal states of the C7. They indicate, for
example, operator errors or problems in communication. This type of
message has the highest display priority. If a problem occurs on the C7, the
currently displayed event message is cleared and a system message is
displayed.
Message texts, screens, information texts and system messages can be
displayed in several languages. A maximum of three of the languages listed
below can be loaded simultaneously and selected by the operator online:
S German
S English
S French
S Italian
S Spanish
Before a C7 can be put into operation, it must be prepared so that it can
visualize data from the C7 CPU. This preparation is known as configuration.
You configure the C7 OP using a computer (programming device/PG) with
the ProTool/Lite configuration software.
Configuration can be divided into three parts:
S Control data
S Assignment of parameters for the interface
S Language selection
Once this configuration has been created, it is downloaded to the C7 OP. For
this step, the computer must be connected to the C7 via an MPI interface.
Once the configuration has been downloaded to the C7 OP, the process
management phase can be started after running a restart on the OP. The
C7 OP then reacts to process signals from the C7 CPU or to operator input
based on the configuration that has been loaded on it.
For information about configuring the C7 OP, refer to the user manuals for
ProTool or ProTool/Lite.
System Messages
Languages
Configuration /
Process
Management
Introduction
To Next Page
Loading...
Need help?
General
