10
Before Using Your Washing
Machine For the First Time
The washing machine must be properly installed and
connected; see installation instructions.
Your appliance was tested before leaving the factory.
To remove any water left over from testing
procedures, the first washing cycle should be carried
out without laundry in the machine.
q Do not load any laundry.
q Turn on the water tap.
q Pour approx. 1 litre / 1 ¾ pt of water into chamber
II of the detergent dispenser.
q Half fill the measuring beaker with detergent and
pour into chamber II. Do not use any special
detergents for delicates or woollens (excessive
foam).
q Set the programme selector to 90 °C
Cottons/coloureds".
The On" control light comes on.
q Press the 3" button.
The Active" control light comes on.
When the End" control light comes on:
q Set the programme selector to Off".
To Next Page
Loading...
