32
This is necessary if very little or no water flows into the
washing machine.
First release the water pressure in the supply hose:
q Turn off the water tap.
q Turn the programme selector to any programme
(except Spin " and Pumping").
q Press the 3" button, and allow the programme to
run for approx. 40 seconds.
q Disconnect the hose from the water tap.
q Rinse the strainer under flowing water.
q Reconnect the hose.
q Disconnect the hose from the back of the washing
machine.
q Pull out the strainer and rinse under running water.
q Insert the strainer and reconnect the hose.
q Turn on the water tap and check whether water is
still discharged. If water is still discharged, check
that the strainer is attached properly.
q Turn off the water tap.
Cleaning inlet
strainers
Cleaning the strainer at the
water tap
Cleaning the strainer on the
washing machine
To Next Page
Loading...
