first time en
25
first time
9 Before using for the
first time
first time
9.1 Performing the initial con-
figuration
On initial start-up or after a reset to
the factory settings, you will need to
make settings.
Tip:Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
HomeConnect app.
Requirement:The appliance has
been installed and connected.
→Page12
1.
Add special salt. →Page26
2.
Add rinse aid. →Page28
3. Switch on the appliance.
→Page33
4. Setting the water softening system.
→Page26
5. Set the amount of rinse aid to be
dispensed. →Page28
6.
Add detergent →Page29.
7. Start the Programme with the
highest cleaning temperature
without tableware.
To remove any marks from water
or other residues, we recommend
you operate the appliance without
tableware before using it for the
first time.
Tip:You can change these settings
and other Basic settings →Page36
at any time.
10 Water softening sys-
tem
Hard water leaves limescale on the
tableware as well as the washing
tank, and parts of the appliance may
become blocked.
To ensure good dishwashing results,
you can treat the water with special
salt and the water softening system.
To avoid damage to the appliance,
water with a hardness above 9°E
must be softened.
10.1 Overview of water hardness settings
You can find an overview of the water hardness values that can be selected
here.
You can find out how hard your water is from your local water company or by
using a water hardness tester.
Water hardness
°E
Hardness range mmol/l Setting value
0 - 8 Soft 0 - 1.1 H00
9 - 10 Soft 1.2 - 1.4 H01
11 - 12 Medium 1.5 - 1.8 H02
13 - 15 Medium 1.9 - 2.1 H03
16 - 20 Medium 2.2 - 2.9 H04
21 - 26 Hard 3.0 - 3.7 H05
27 - 38 Hard 3.8 - 5.4 H06
To Next Page
Loading...
Need help?
General
