Transportation, storage and disposal en
51
18.1 Clean wastewater pump
Large remnants of food or foreign
bodies can block the waste water
pump. As soon as the rinsing water
no longer drains properly, the waste
water pump must be cleaned.
WARNING
Risk of injury!
Sharp and pointed objects or frag-
ments of glass may block the waste
water pump and cause injury.
▶ Remove any foreign bodies care-
fully.
1. Disconnect the appliance from the
power supply.
2. Remove the top and bottom bas-
ket.
3. Remove the filter system.
4. Scoop out any water.
Use a sponge if necessary.
5. Prise off the pump cover using a
spoon and grip it by the
crosspiece.
6. Lift the pump cover inwards at an
angle and remove.
a You can now reach the impeller
with your hand.
7. Remove any remnants of food and
foreign bodies in the area of the
impeller.
8. Insert the pump cover and press
down .
a The pump cover clicks into posi-
tion.
9. Install the filter system.
10.Insert the top and bottom basket.
19 Transportation, stor-
age and disposal
19.1 Removing the appliance
1. Disconnect the appliance from the
mains power supply.
2. Turn off the water tap.
3. Detach the drainage connection.
4. Detach the drinking water connec-
tion.
5. Loosen any screws fastening the
appliance to cabinet parts.
6. Remove the base panel if fitted.
7. Pull the appliance out carefully,
along with the hose behind it.
To Next Page
Loading...
Need help?
General
