EasyManua.ls Logo

Siemens TI351 Series - Page 25

Siemens TI351 Series
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Trouble shooting
50
The brewing unit cannot be
removed.
The brewing unit is not in the
removal position (e.g. frost pro-
tection activated).
Switch the appliance on again.
The appliance cannot be oper-
ated, LEDs lit up or flashing.
The appliance is in demo mode. Hold k button for at least 5 seconds
to deactivate demo mode. Remove the
water tank, fill with fresh water and
re-insert.
The grinder will not start. The appliance is too hot. Disconnect the appliance from the
mains and leave to cool down for
1 hour.
( LED flashes. The door is not closed properly. Press the door firmly closed.
The appliance is too hot. Disconnect the appliance from the
mains and leave to cool down for
1 hour.
( LED lit up despite empty
drip tray - what to do?
Emptying is not detected when
the appliance is off.
When the appliance is switched on,
remove and re-insert the drip tray.
' LED lit up despite water
tank being full.
Water tank wrongly inserted. Insert water tank correctly.
Carbonated water in the water
tank.
Fill the water tank with fresh tap water.
Float is stuck in the water tank. Remove the water tank and clean thor-
oughly.
New water filter not rinsed
according to the instructions.
Rinse the water filter according to the
instructions and then switch on.
Air in the water filter. Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 41
Water filter is old. Insert a new water filter.
Limescale deposits in the water
tank can block up the system.
Thoroughly clean the water tank and
start calc'nClean. ~ "Calc’nClean
service programme" on page 47
' LED flashes and all bever-
age LEDs flashing.
Water tank is missing or not
inserted correctly.
Insert water tank correctly.
The pipe system in the appli-
ance is dry.
Insert water tank correctly.
Fill the water tank with fresh tap water.
Do not fill with carbonated water.
Air in the water filter. Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 41
www.devicemanuals.eu/

Related product manuals