Siemens TQ507DF03/10 Information For Use

Troubleshooting en
31
Fault Cause and troubleshooting
No milk intake by the
milk system.
Order for connecting the milk container and milk sys-
tem is wrong.
▶ First insert the milk system into the outlet and then
the milk container.
Milk tube not immersed in milk.
▶ Use more milk.
▶ Check whether the milk tube is immersed in the
milk.
Milk froth is too cold. Milk is too cold.
▶ Use lukewarm milk.
Appliance is not dis-
pensing hot water.
Milk system is soiled.
▶ Clean the milk system in the dishwasher.
Milk system cannot be
assembled or disas-
sembled.
Order of assembly is wrong.
▶ First connect the milk system and then the milk
container. When disassembling, you must first re-
move the milk container and then the milk system.
Appliance is not dis-
pensing drinks.
Air is in the water filter.
1. Immerse the water filter in water with the opening
facing upwards until no more air bubbles escape.
2. Reinsert the filter.
→"Inserting and activating the water filter", Page17
▶ Firmly press the water filter straight down into the
tank connection.
Residues of limescale remover are blocking the water
tank.
1. Remove the water tank.
2. Clean the water tank thoroughly.
There is dripping wa-
ter on the inner floor
of the appliance.
Drip tray was removed too soon.
▶ Wait a few seconds after the last drink was dis-
pensed before removing the drip tray.
Brewing unit cannot
be removed.
Brewing unit is not in the removal position.
▶ Switch the appliance back on.
Appliance cannot be
operated.
Change displays.
Appliance is in demo mode.
1. Remove the water tank and fill with fresh cold wa-
ter.
2. Reinsert the water tank.
Grinder won't start. Appliance is too hot.
1. Disconnect the appliance from the mains.
2. Wait 1hour so the appliance can cool down.

Siemens TQ507DF03/10 Specifications

General

Brand	Siemens
Model	TQ507DF03/10
Category	Coffee Maker
Language	English