1
Safety instructions
The washing machine is heavy take care when lifting it.
Warning: Frozen hoses may tear/burst. Do not install the washing machine in an area where
there is a risk of frost or outdoors.
Do not hold onto protruding parts (e.g. loading door) when lifting. Washing machine may
be damaged.
Before transporting the appliance, always drain dispensers. aPage 8
In addition to the safety information listed here, the local water and electricity supplier may
have special requirements.
If in doubt, have the appliance connected by a technician.
Lay hoses and cables in such a way that there is no risk of stumbling.
Environmental disposal
Dispose of packaging in an environmentally friendly manner.
This appliance has been identified in accordance with the European Directive 2002/96/EG
on Waste Electrical and Electronic Equipment (WEEE).
The Directive specifies the framework for an EU-wide valid return and recycling of waste
appliances.
Installation area
Stability is important to prevent the machine from moving!
The installation area must be firm and level.
Soft floors/floor coverings are not suitable.
If installing the appliance on a base
Always secure the washing machine feet with retention plates *.
* Order no. WMZ 2200, WX 9756, CZ 110600, Z 7080X0
If installing the appliance on a wooden joist ceiling
If possible, install the washing machine in a corner.
Screw a water-resistant wooden panel (min. 30 mm thick) to the floor.
Always secure the washing machine feet with retention plates.
* Order no. see above
When installation is on a platform with drawer *
* Order no. WMZ 20460, WZ 20460
Built-under/Built-in appliance
Build-under/Build-in before connection to the power supply.
Installed in between kitchen units (built-under or built-in)
60 cm cavity width required.
Install washing machine only under a continuous worktop connected firmly to the adjacent
cupboards.
Built-under
Risk of electric shock!
Instead of the appliance cover panel, it is essential to have a technician fit a sheet metal
cover *. * Order no. WMZ 2043, WZ 20430
60 cm cavity width required.
2
Scope of delivery depending on model
not included in product package:
When drainage is into a siphon, a Ø 2440 mm hose clip (specialist outlet) is also required.
aWater connection, Page 4
Useful tools:
Spirit level for aligning the washing machine.
Size 13 socket wrench:
for loosening the transportation protection devices aPage 3 and
size 17: for aligning the appliance feet. aPage 5
Hose and cable lengths depending on model
Connection on left side
or
Connection on right side
Note: If the hose holders are used, the possible hose lengths are reduced!
Available from dealer/customer service:
Extension for Aqua-Stop or cold water inlet hose (approx. 2.50 m).
Order no. WMZ2380, WZ10130, CZ11350, Z7070X0
Longer supply hose (approx. 2.20 m), for standard model.
To Next Page
Loading...
