12
What to do if
Drain pump blocked
Set programme selector to Off, pull out the mains plug.
1. Open and remove service flap.
2. Take the drainage hose out of the holder.
Remove sealing cap, allow detergent solution to flow out.
Put the closing cap back on the hose.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (fan impeller
in the detergent-solution pump must rotate).
5. Reinsert and screw on pump cover. Handle is upright.
Insert the drain hose into the holder.
6. Insert and close service flap.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser B/C and start the Empty programme.
Drainage hose on the siphon blocked
Set programme selector to Off, pull out the mains plug.
1. Loosen hose clip, carefully remove drainage hose (residual water).
2. Clean drainage hose and siphon spigot.
3. Re-attach drainage hose and secure connection point with hose clip.
Filters blocked in water inlet hose
Risk of electric shock!
Do not immerse Aqua-Stop safety device in water (contains electric valve).
First, release water pressure in the supply hose:
1. Turn off the tap!
2. Select any programme (except Spin/Empty).
3. Select Start/Reload. Leave programme for approx. 40 seconds.
4. Set programme selector to Off. Pull out the mains plug!
5. Clean the filters:
Disconnect the hose from the water tap.
Clean filter with small brush.
and/or for standard and Aqua-Secure models:
remove hose from the rear of the appliance.
Take out filter with pliers and clean.
6. Connect the hose and check for leaks.
Risk of scalding!
Allow detergent solution to cool
down.
13
Emergency release
e.g. if power failure occurs
The programme continues running when the power supply is restored. If the washing is still
to be removed, the door can be opened as described below:
Risk of scalding!
Wash liquor and washing may be hot. If required, leave to cool down.
Do not reach into the drum in case it is still rotating.
Do not open the door if you can still see water through the glass.
1. Set programme selector to Off, pull out the mains plug.
2. Drain detergent solution.
aPage 12
3. Pull down emergency release (
aarrow) with a tool and release.
4. Door can then be opened.
Risk of scalding!
Allow detergent solution to cool down.
Close the mains water tap.
To Next Page
Loading...
