en operation
32
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page18
3. If required, add the care product.
4. Push in the detergent drawer.
13.8 Starting the programme
Requirement:A programme has
been set.
→"Setting a programme", Page30
▶ Press inicio pausa + carga.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.The display shows either the
programme duration or the "Ready
in" time.
a After the programme has ended,
the display shows: "End".
13.9 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press inicio
pausa + carga.
3. To resume the programme, after
the desired soaking time, press
inicio pausa + carga.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:A programme has
started.
→"Starting the programme",
Page32
1. Press inicio pausa + carga.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page22
2. Open the appliance door.
3. Add or remove laundry.
4. Close the appliance door.
5. Press inicio pausa + carga.
13.11 Cancelling the pro-
gramme
1. Press inicio pausa + carga.
2. Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the programme.
– If the water level is high, start
the programme or select a
suitable programme for draining.
→"Programmes", Page25
3.
Remove the laundry →Page32.
13.12 Unloading the laundry
1. Open the appliance door.
2. Remove the laundry.
13.13 Switching off the appli-
ance
1. Turn the programme selector to .
2. Turn off the tap.
To Next Page
Loading...
