Siemens WG54B2A0ES - Page 57

Troubleshooting en
57
Fault Cause and troubleshooting
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶ Redistribute the laundry in the drum.
Note:Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶ Start the programme.
Detergent residue on
the damp washing.
Detergents may contain water-insoluble substances
that deposit on the laundry.
▶ Start the programme.
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
1. Check whether the detergent used is suitable.
→"Detergents and care products", Page31
2. Drain the dispenser.
→"Cleaning the detergent drawer", Page43
3. Clean the dispenser.
4. Refill the dispenser.
→"Filling the dispensers", Page36
Basic dosage is not correctly adjusted.
▶ If intelligent dosing is activated, reduce the basic
dosage →Page37.
Detergent residue on
the dry laundry.
Detergents may contain water-insoluble substances
that deposit on the laundry.
▶ Brush out the laundry after washing and drying.
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
1. Check whether the detergent used is suitable.
→"Detergents and care products", Page31
2. Drain the dispenser.
→"Cleaning the detergent drawer", Page43
3. Clean the dispenser.
4. Refill the dispenser.
→"Filling the dispensers", Page36
Basic dosage is not correctly adjusted.
▶ If intelligent dosing is activated, reduce the basic
dosage →Page37.
Insufficient cleaning. Basic dosage not adjusted.
▶ If intelligent dosing is activated, adjust the basic
dosage →Page37.