Basic operation en
43
3. Fold the measuring aid down and
click it into place.
4. Push in the detergent drawer.
Adding detergent and care
product
Notes
¡ Please read the information in the
"Safety" →Page4 and "Preventing
material damage" →Page11 sec-
tions to ensure that you use the
appliance safely.
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
Requirement:Find out the optimum
dosage for "detergent and care
product." →Page39
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page26
3. If required, add the care product.
4. Push in the detergent drawer.
Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press inicio/pausa+carga .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a In each case, the TimeLight altern-
ately shows the remaining pro-
gramme duration and the current
programme status on the floor.
a After the programme has ended,
the display shows: "End".
a The TimeLight is projected onto
the floor at the end of the pro-
gramme.
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
1. Press inicio/pausa+carga .
2. Press termin. repeatedly until
the display indicates the desired
"Ready in" time.
3. Press inicio/pausa+carga .
Soaking laundry
You can soak the laundry before
washing in the appliance by pausing
the programme.
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press inicio/
pausa+carga .
3. To resume the programme, after
the desired soaking time, press
inicio/pausa+carga .
To Next Page
Loading...
