EasyManua.ls Logo

Siemens WM14K268EE - Information on the Display Panel; Faults and What to Do about Them

Siemens WM14K268EE
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Faults and what to do about them.
26
Information on the display panel
Faults and what to do about them.
Display Cause/remedial action
YES The washing machine door is unlocked. It is possible to add laundry.
NO Temperature too high. Wait until the temperature drops.
Water level too high. Not possible to add laundry. Close the washing machine
door immediately, if necessary. Select Start/Reload to continue the pro-
gramme.
v flashes Laundry may become trapped. Open and close the washing machine door
again and select Start/Reload.
If necessary, push the washing machine door closed or remove the laundry and
push it closed again.
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
E:17 Turn the water tap on fully,
supply hose kinked or trapped,
water pressure too low. Clean the filter. ~ Page 24
E:18 Detergent solution pump blocked. Clean the detergent solution pump.
~ Page 23
Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
~ Page 24
E:23 Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales ser-
vice.
w Childproof lock activated; deactivate it. ~ Page 20
¼ flashes Too much foam detected, a rinse cycle has been switched on ~ Page 21
Other displays Switch off the appliance, wait for five seconds and switch it back on again. If the
indicator appears again, call the after-sales service ~ Page 28
Faults Cause/remedial action
Water is leaking out. Attach/replace the drainage hose correctly.
Tighten the screw connection of the supply hose.
No water supply.
Detergent is not dis-
pensed.
Start/Reload not selected?
Tap not turned on?
Filter blocked? Clean the filter. ~ Page 24
Supply hose kinked or trapped?
Washing machine door
cannot be opened.
Safety function active. Programme stopped?
– – – 0 (Rinse hold = without final spin) selected?
Can be opened by emergency release only? ~ Page 25
Programme does not
start.
Start/Reload or "Ready in" time selected?
Washing machine door closed?
w Childproof lock activated? Deactivate it. ~ Page 20

Table of Contents

Related product manuals