Siemens WM14N122 - Clean the Water Inlet Filters

en Cleaning and servicing
44
Clean the water inlet filters.
Clean the filters in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
In order to be able to clean the filters,
you must first empty the water inlet
hose.
1. Turn off the tap.
2. Set a programme, except for
Spülen, Schleudern or
Abpumpen.
3. Start the programme and leave it
to run for approx. 40seconds.
4. Switch off the appliance.
5. Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:Please read the information in
the "Safety" →Page4 and "Prevent-
ing material damage" →Page11 sec-
tions to ensure that you use the appli-
ance safely.
Requirement:The water inlet hose is
empty.
1. Remove the water inlet hose from
the tap.
2. Clean the filter with a small brush.
3. Connect the water inlet hose and
check for leaks.
Cleaning the filter on the appliance
Note:Please read the information in
the "Safety" →Page4 and "Prevent-
ing material damage" →Page11 sec-
tions to ensure that you use the appli-
ance safely.
Requirement:The water inlet hose is
empty.
→"Emptying the water inlet hose",
Page44