Siemens WM14N2G4 - Page 40

en Troubleshooting
40
Fault Cause and troubleshooting
"E:35 / -10" ▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page49
flashes. The automatic voltage control system detects an un-
authorised voltage drop.
▶ No remedial action possible.
Note:If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up. Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page30
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page23
flashes. Door is not closed.
▶ Close the door.
Laundry is caught in the door.
▶ Remove any trapped laundry.
Drum cleaning is required.
▶
→"Cleaning the drum", Page33
"E:30/-20" Detergent dosage is too high.
▶ Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water is added.
▶ Do not add any extra water to the appliance while it
is operating.
Solenoid valve defective.
▶ Call the after-sales service.
→"Customer Service", Page49