Siemens WM14N2O3DN - Page 48

en Troubleshooting
48
Fault Cause troubleshooting
The door cannot beopened. ––– is activated.
▶
Continue the programme by select-
ing Spin or Drain and pressing
⁠ .
→"Resuming the programme when
the programme status is Rinse
Hold", Page36
The temperature is too high.
▶
Wait until the temperature has
dropped.
▶
→"Cancelling the programme",
Page36
Water level is too high.
▶
Start the Drainprogramme.
Power failure.
▶
Open the door using the emergency
release.
→"Emergency release", Page53
The water is not draining. Drain pipe or water outlet
hose is blocked.
▶
Clean the drain pipe and the water
outlet hose.
Drain pipe or water drain
hose is caught or jammed.
▶
Ensure that the drain pipe and wa-
ter drain hose are not kinked or
trapped.
Drain pump is blocked.
▶
→"Cleaning the drain pump",
Page40
––– is activated.
▶
Continue the programme by select-
ing Spin or Drain and pressing
⁠ .
→"Resuming the programme when
the programme status is Rinse
Hold", Page36
The water outlet hose is con-
nected too high.
▶
Install the water outlet hose at a
maximum height of 1 metre.
→"Technical specifications",
Page57
Water is not flowing in. De-
tergent is not being dis-
pensed.
You have not pressed ⁠ .
▶
Press ⁠ .
The filters in the water inflow
are blocked.
▶
"Clean the filters in the water in-
flow" →Page43.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is
kinked or jammed.
▶
Ensure that the water inlet hose is
not kinked or jammed.