Siemens WM14N2O3DN - Malfunctions

Troubleshooting en
47
Fault Cause troubleshooting
⁠ The tap is turned off.
▶
Turn on the tap.
The water inlet hose is
kinked or jammed.
▶
Ensure that the water inlet hose is
not kinked or jammed.
lights up. The temperature is too high.
▶
Wait until the temperature has
dropped.
▶
→"Cancelling the programme",
Page36
Water level is too high.
▶
Start the Drainprogramme.
Laundry is caught in the
door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press ⁠ to start the programme.
flashes. Door is not closed. 1. Close the door.
2. Press ⁠ to start the programme.
All other error codes. Malfunction
▶
Call the after-sales service.
→"Customer Service", Page55
Malfunctions
Fault Cause troubleshooting
The appliance is not work-
ing.
The mains plug of the power
cord is not plugged in.
▶
Connect the appliance to the power
supply.
The circuit breaker is faulty.
▶
Check the circuit breaker in the
fuse box.
There has been a power cut.
▶
Check whether the lighting in your
kitchen or other appliances are
working.
The programme does not
start.
You have not pressed ⁠ .
▶
Press ⁠ .
Door is not closed. 1. Close the door.
2. Press ⁠ to start the programme.
Childproof lock is activated.
▶
→"Deactivating the childproof
lock", Page37
⁠ is activated.
▶
Check whether ⁠ is activated.
→"Buttons", Page23
Laundry is caught in the
door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press ⁠ to start the programme.