en Faults and what to do about them.
40
2. Drain the water
. ~ Page 37
3. Use a tool to pull the emergency
release downwards and then
release.
The washing machine door can then
be opened.
Information on the display panel
Indicator Cause/remedy
® off The door is unlocked at the end of the programme or when paused, laundry can be
added/removed
® is lit up ■ During the programme. Door locked.
■ Paused: Temperature too high. Wait until the temperature drops.
■ Paused: Spin speed too high. Wait until the drum comes to a halt.
■ Paused: Water level too high. It is not possible to add laundry. Touch ‹ to con-
tinue the programme.
® flashes ■ Slowly: The door cannot currently be locked or unlocked. Waiting time
required.
■ Quickly: Close the door because water can flow out from the laundry.
® and the
sensoFresh î indic
ator light flash
The door cannot be opened due to programme-related technical reasons.
When the lights go off, the door can be opened.
‹ off At the end of the programme, while the door is open
‹ is lit up After the programme has started
‹ is flashing Before the programme starts, paused
| is lit up Water pressure too low, may increase the length of the programme.
| is flashing No water supply:
■ Turn the tap on fully,
■ The supply hose is kinked/trapped,
■ Clean the filter if necessary. ~ Page 38
w 3 sec is lit up The childproof lock is activated – deactivate it. ~ Page 33
w 3 sec is flashing The childproof lock is activated – the programme selector has been turned or the
control panel touched.
ä is flashing Run the äDrum Clean î 90 °C programme or a 60 °C programme to clean and
care for the drum and the outer tub.
Notes
■ Run the programme without laundry.
■ Use standard washing powder or a detergent that contains bleach. To prevent
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
■ Switching the information signal on/off
To Next Page
Loading...
