Siemens WM14VKH1ES - Activating Wi-Fi on the Appliance; Deactivating Wi-Fi on the Appliance; Software Update; Resetting the Appliance Network Settings

en HomeConnect
46
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡ Press inicio/pausa+carga.
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
16.6 Activating Wi-Fi on the
appliance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold  for approx. 3
seconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press inicio/pausa+carga re-
peatedly until the display shows
On.
a Wi-Fi is activated.
Note:If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
16.7 Deactivating Wi-Fi on the
appliance
1. Press and hold  for at least
threeseconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press inicio/pausa+carga re-
peatedly until the display shows
OFF.
a Wi-Fi is deactivated.
Note:If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
16.8 Software update
Requirement:The display shows
Upd.
1. Press and hold  for approx. 3
seconds.
2. Set the programme to position6.
a UPd appears on the display.
3. Press inicio/pausa+carga.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note:The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
16.9 Resetting the appliance
network settings
1. Press and hold  for at least
3seconds.
2. Set the programme to position5.
a The display shows rES.
3. Press inicio/pausa+carga.
a The display shows .
4. Press inicio/pausa+carga.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
Tip:If you wish to operate your appli-
ance again via the HomeConnect
app, you will need to reconnect it to
the Wi-Fi and to the HomeConnect
app.