Siemens WM14VKH1ES - Page 58

en Troubleshooting
58
Fault Cause and troubleshooting
"E:30 / -80" Unapproved extension installed on the water drain
hose.
▶
Remove any unapproved extensions from the water
hose. Connecting the appliance
"E:36 / -25 / -26" Drain pump is blocked.
▶
→"Cleaning the drain pump", Page52
"E:38 / -25 / -26" Drain pump is blocked.
▶
→"Cleaning the drum", Page49
if the fault is displayed again,
▶
→"Cleaning the drain pump", Page52
Inlet opening of the rubber gasket is blocked.
▶
→"Cleaning the intake opening in the rubber gas-
ket", Page54
"E:10 / -00 / -10 /
-20"
The pump for the intelligent dosing system is blocked.
1. Switch off the appliance.
2. Clean the pump unit.
→"Cleaning the detergent drawer", Page50
3. If this indicator appears again, call our after-sales
service.
→"Customer Service", Page70
Note:You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→"Buttons", Page23
The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
▶
Clean the water inflow filter →Page55.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
"E:35 / -10" There is water in the base trough.
▶
Turn off the water tap.
▶
Call the after-sales service.
→"Customer Service", Page70
The appliance is leaking.
▶
Turn off the water tap.