Siemens WM14VKH1ES - Page 60

en Troubleshooting
60
Fault Cause and troubleshooting
The appliance is not
working.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The programme does
not start.
You have not pressedinicio/pausa+carga.
▶
Press inicio/pausa+carga.
Door is not closed.
1. Close the door.
2. Press inicio/pausa+carga to start the programme.
Childproof lock is activated.
▶
→"Deactivating the childproof lock", Page41
-termin. ⁠+ is activated.
▶
Check whether -termin. ⁠+ is activated.
→"Buttons", Page23
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press inicio/pausa+carga to start the programme.
The detergent drawer has not been pushed in as far
as it can go.
▶
Push the detergent drawer in as far as it will go.
The pump for the intelligent dosing system is blocked.
1. Switch off the appliance.
2. Clean the pump unit.
→"Cleaning the detergent drawer", Page50
3. If this indicator appears again, call our after-sales
service.
→"Customer Service", Page70
Note:You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→"Buttons", Page23
The door cannot
beopened.
is activated.
▶
Continue the programme by selecting centrifu-
gado / centrifugação or desaguar / escoamento
and pressing inicio/pausa+carga.
→"Resuming the programme when the programme
status is Rinse Hold", Page40
The temperature is too high.
▶
Wait until the temperature has dropped.