Siemens WM14VKH1ES - Page 65

Troubleshooting en
65
Fault Cause and troubleshooting
Creasing.
▶
Select the programmes that are suitable for the
type of fabric.
→"Programmes", Page26
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
▶
Start the centrifugado / centrifugaçãoprogramme.
menos is activated.
▶
Select the programmes that are suitable for the
type of fabric.
→"Programmes", Page26
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the centrifugado / centrifugaçãoprogramme.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶
Redistribute the laundry in the drum.
Note:Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the centrifugado / centrifugaçãoprogramme.
Detergent residue on
the damp washing.
Detergents may contain water-insoluble substances
that deposit on the laundry.
▶
Start the programme.
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
1. Check whether the detergent used is suitable.
2. Drain the dispenser.
→"Cleaning the detergent drawer", Page50
3. Clean the dispenser.