Siemens WM14XMH0EU - Activating Wi-Fi on the Appliance; Deactivating Wi-Fi on the Appli- Ance; Software Update; Resetting the Appliance Network Settings

en HomeConnect
44
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡ Press Start/Reload .
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
Activating Wi-Fi on the appli-
ance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold Remote Start ⁠
for approx. 3 seconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press Start/Reload repeatedly
until the display shows On.
a Wi-Fi is activated.
Note:If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Deactivating Wi-Fi on the ap-
pliance
1. Press and hold Remote Start ⁠
for at least threeseconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press Start/Reload repeatedly
until the display shows OFF.
a Wi-Fi is deactivated.
Note:If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement:The display shows
UdP.
1. Press and hold Remote Start ⁠
for approx. 3 seconds.
2. Set the programme to position6.
a UPd appears on the display.
3. Press Start/Reload .
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note:The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance net-
work settings
1. Press and hold Remote Start ⁠
for at least 3seconds.
2. Set the programme to position5.
a The display shows rES.
3. Press Start/Reload .
a The display shows .
4. Press Start/Reload .
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
Tip:If you wish to operate your appli-
ance again via the HomeConnect
app, you will need to reconnect it to
the Wi-Fi and to the HomeConnect
app.
Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the HomeCon-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip:For further information and de-
tails about the availability of Remote
Diagnostics in your country, please