39
Information on the display panel
Display Cause/Remedy
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
– Washing may be caught. Please open and close washing ma-
chine door again and select Inicio/Carga Ü (Start/Pause).
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
Please open tap – Turn on tap fully.
–Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 37
Please clean pump – Drain pump blocked. Clean the drain pump. ~ Page 35
– The water drainage pipe/drain hose is blocked. Clean the drain-
age hose on the siphon. ~ Page 36
Pause: Reload is not
possible
Water level or temperature is too high.
Select Inicio/Carga Ü (Start/Pause) to continue the programme.
Door cannot be un-
locked: Water level
or temperature is too
high
Water level or temperature is too high.
Select Inicio/Carga Ü (Start/Pause) to continue the programme.
aquaStop has been
activated!
Please call customer
service
not applicable without Aqua-Stop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 42
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not op-
erated for a prolonged period. In order to cancel the programme,
press any button. ~ Page 32
Cooling down the
detergent solution
To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Other displays
Error E: XXX
Switch off appliance, wait 5 seconds and switch on again. If the dis-
play is indicated again, call customer service. ~ Page 42
To Next Page
Loading...
