34
The same detergent or softener can be topped up at any
time. If the product/manufacturer is changed, we recommend
cleaning the dispensers beforehand. ~ Page 41 If required,
adjusting the basic dosage. ~ Page 34
Standard settings
Ø If required, change basic dosages for detergent and softener:
The basic dosage amount to be set corresponds:
For detergents – to the manufacturer’s recommendation for
normal soiling and to the particular water hardness.
For softeners – to the manufacturer’s recommendation for
medium softness and to the particular water hardness.
This information can be found on the package label of the
detergent/softener or ask the manufacturer directly.
To determine the existing water hardness, use a test strip or
check with your water utility company.
My water hardness:
Here is an example of the detergent dosage on a package
label:
²
– Factory setting of the basic dosage: for detergent 75 ml and
for softener 36 ml.
– In the case of more concentrated detergents reduce the
basic dosage amount.
Ø If intensive foaming occurs repeatedly during washing, please
check the basic dosage setting and dosage strength.
Furthermore, some liquid detergents may have a tendency to
excessive foaming. If the basic dosage settings and dosage
strengths are correct, it is recommended to use a different
liquid detergent.
Change basic dosage amount. ~ Page 38
Ø If required, convert i-Dos iIô dispenser contents.
Instead of softener, a second liquid detergent can also be
used in dispenser i-Dos iIô.
Degree of soiling →
Water hardness ↓
light normal heavy very
heavy
soft/medium 55 ml 75 ml 120 ml 160 ml
hard/very hard 75 ml 95 ml 150 ml 180 ml
To Next Page
Loading...
