en Appliance settings
42
Programme end during rinse
hold
In the display panel, $ flashes, and the
preset spin speed and remaining
programme length are displayed for the
selected programme.
Continue the programme by:
■ Pressing the Ü button or
■ Changing the spin speed, or setting
the programme selector to Empty
and then pressing the Ü button.
Programme end
- 0 - and Ï appear in the display panel.
The Ü button indicator lamp is off.
Removing laundry/switching
off the appliance
1. Open the door and remove the
laundry.
2. Press the # button. The appliance is
switched off.
3. Turn off the tap.
Note: Not required for Aqua-Stop
models.
Notes
■ Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■ Wipe the rubber seal dry.
■ Leave the door and detergent
drawer open so that any residual
water can evaporate. ~ Page 44
■ Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
■ If the display panel goes off at the
end of a programme, the energy-
saving mode is active. Press any
button to activate the panel.
Q Appliance settings
Appli ance settings
You can change the following settings:
■ The volume of the buttons and the
information signals (e.g. at the end
of the programme)
■ Select/deselect the appliance's
automatic switch-off function
~ Page 13
■ Switch the drum-care information
signal on/off (depending on the
model).
You will need to activate the setting
mode in order to change these settings.
3RVLWLRQV
To Next Page
Loading...
