41
Faults, what to do?
Faults Cause/Remedy
Water is running out. – Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
Water not flowing in.
Detergent not
washed in.
– Start/Reload
Ü not selected?
– Tap not open?
– Filter blocked? Clean the filter. ~ Page 38
– Supply hose kinked or jammed?
Washing-machine
door cannot be
opened.
– Safety function active. Stop programme?
– Rinse Hold
$ (without final spin) selected?
– Can be opened via emergency release only? ~ Page 39
Programme does
not start.
– Start/Reload
Ü or Finish in time selected?
– Door closed?
– Childlock active? Deactivate.
Detergent solution is
not drained.
– Rinse Hold
$ (without final spin) selected?
– Clean the drain pump. ~ Page 36
– Clean outlet pipe and/or drainage hose.
Water not visible in
the drum.
Not a fault – water below the visible area.
Spin result not
satisfactory.
Washing wet/too
damp.
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
– Less Ironing
æ selected? ~ Page 30
– Too low speed selected? ~ Page 24
Spin cycle actuated
several times.
Not a fault – unbalanced load detection system adjusts imbalance.
Residual water in the
dispenser for care
product.
– Not a fault – effect of the care product not impaired.
– If required, clean insert. ~ Page 36
Odour formation in
the washing
machine.
Run Cotton 90 °C programme without washing.
Use standard detergent.
Loud noise
formation, vibrations
and “wandering”
during spin cycle.
– Appliance aligned?
Align the appliance. ~ Page 56
– Appliance feet fixed?
Secure appliance feet. ~ Page 56
– Transportation safety devices removed?
Remove transportation protection devices. ~ Page 50
Can be opened via emergency release only?
www.devicemanuals.eu
Can be opened via emergency release only?
time selected?
www.devicemanuals.eu
time selected?
(without final spin) selected?
www.devicemanuals.eu
(without final spin) selected?
Page 36
www.devicemanuals.eu
Page 36
– Clean outlet pipe and/or drainage hose.
www.devicemanuals.eu
– Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
www.devicemanuals.eu
Not a fault – water below the visible area.
– Not a fault – unbalanced load detection system has stopped the
www.devicemanuals.eu
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
www.devicemanuals.eu
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
www.devicemanuals.eu
Distribute small and large items of washing in the drum.
Less Ironing
www.devicemanuals.eu
Less Ironing
– Too low speed selected?
www.devicemanuals.eu
– Too low speed selected?
Not a fault – unbalanced load detection system adjusts imbalance.
www.devicemanuals.eu
Not a fault – unbalanced load detection system adjusts imbalance.
– Not a fault – effect of the care product not impaired.
www.devicemanuals.eu
– Not a fault – effect of the care product not impaired.
To Next Page
Loading...
Need help?
General