46
4.
Remove sealing cap, allow detergent solution to flow out.
Have a suitable container ready.
Push up the closing cap and place the drain hose back in its
holder.
Note: Residual water may run out.
5.
Carefully unscrew the pump cover. Clean the interior, pump
cover thread and pump housing (fan impeller in the
detergent-solution pump must rotate).
6.
Reinsert and screw on pump cover. Handle should be
vertical.
7.
Close the service flap. If required, lock disengaged service
flap beforehand.
²
To prevent unused detergent from flowing into the outlet during
the next wash cycle: Pour 1 litre of water into dispenser ÀÁ
and start the Drain programme.
Drainage hose on the siphon blocked
1.
Switch off the appliance. Pull out the mains plug!
Note: Residual water may run out!
2.
Loosen hose clip, carefully remove drainage hose.
3.
Clean drainage hose and siphon spigot.
4.
Re-attach drainage hose and secure connection point with
hose clip.
Filter blocked in water inlet hose
First, release water pressure in the supply hose:
1.
Turn off the tap!
2.
Select any programme (except Spin/Drain).
3.
Select Ü (Start/Pause). Leave programme for approx.
40 seconds.
4.
Press the # button. Appliance is switched off. Pull out the
mains plug!
5.
Clean the filter:
To Next Page
Loading...
