49
Information on the display panel
Display Cause/Remedy
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
– Washing may be caught. Please open and close washing ma-
chine door again and select
Ü (Start/Pause).
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
Please re-fill
i-Dos
iIô, i-Dos ô
container
Level i-Dos container below minimum, Top up ~ Page 34
i-Dos
iIô, i-Dos ô
error; deactivate
i-Dos
iIô, i-Dos ô
Set i-Dos iIô, i-Dos ô to off.
Call customer Service. Appliance can continue to be operated with
manual dosage. ~ Page 38
Please close deter-
gent drawer.
Push in detergent drawer correctly. ~ Page 34
Please open tap – Turn on tap fully.
–Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 46
Please clean pump – Drain pump blocked. Clean the drain pump.
– The water drainage pipe/drain hose is blocked. Clean the drain-
age hose on the siphon. ~ Page 46
Pause: Reload is not
possible
Water level or temperature is too high.
Select
Ü (Start/Pause) to continue the programme.
Door cannot be un-
locked: Water level
or temperature is too
high
Water level or temperature is too high.
Select
Ü (Start/Pause) to continue the programme.
aquaStop has been
activated!
Please call customer
service
not applicable without Aqua-Stop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 51
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not op-
erated for a prolonged period. In order to cancel the programme,
press any button. ~ Page 40
Water cooling To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Other displays
Error E: XXX
Switch off appliance, wait 5 seconds and switch on again. If the dis-
play is indicated again, call customer service. ~ Page 51
To Next Page
Loading...
