1. Open and remove the maintenance cover.
2. Carefully unscrew the pump cover - do not remove it completely.
3. Let the water drain into a shallow container (let the remainder drip
onto a floor cloth). Repeat the operation until there is no water left.
4. Remove the pump cover. Remove foreign material/fluff from inside the
pump.
5. Clean the interior, pump cover thread and pump housing
(fan impeller in the detergent solution pump must be able to rotate).
6. Refit the pump cover and screw on tightly.
7. Insert the maintenance cover and close it.
To prevent unused detergent from flowing into the outlet during the next
wash: pour 1 litre of water into dispenser II and start the ÅSpin/Empty
l programme.
Filter in the water inlet hose
Reduce the water pressure in the supply hose:
1. Turn off the tap.
2. Select any programme (except ÅSpin/Empty l).
3. Press Start/Reload .Leave programme running for approx. 40 seconds.
4. Set the programme selector to Off. Pull out the mains plug.
Clean the filter:
1. Remove the hose from the tap.
Clean the filter with a small brush.
or
Remove the hose from the rear of the appliance.
Remove filter with pliers and clean.
2. Reconnect the hose and check for leaks.
1
2
1
2
– Risk of scalding. Allow detergent
solution to cool down.
– Turn off the tap.
11
Consumption values
Programme
Additional
function
Load
Electricity con-
sumption
***
Water***
Programme
duration
***
Cottons Êü20
- 4,5 kg 0,18 kWh 51 l 1:41 h
Cottons Êü40 *
- 4,5 kg 0,69 kWh 51 l 1:41 h
Cottons Êü60 *
- 4,5 kg 0,85 kWh 51 l 1:50 h
Cottons Êü90
- 4,5 kg 1,50 kWh 58 l 2:15 h
Easy-Care Ïü40 *
- 2,5 kg 0,49 kWh 48 l 1:27 h
Delicate/Silk 5ü30
- 2,0 kg 0,26 kWh 34 l 0:43 h
Wool düÉ30
- 2,0 kg 0,13 kWh 43 l 0:40 h
* Programme setting for testing in accordance with valid standard EN60456.
Note on comparative tests: For testing the test programmes, wash the specified load using the
maximum spin speed.
Programme
Additional
function
Load Annual energy consumption
Annual water
consumption
Cottons Ê 40/60
eco Perfect
** 4,5/2,25kg 155 kWh 8900 l
** Programme setting for testing and energy labelling in accordance with EU directive 2010/30/
EU with cold water (15 °C).
*** The values deviate from the indicated values depending on water pressure, hardness, and inlet
temperature, ambiente temperature, type, amount and soiling of the laundry, detergent used,
fluctuations in the power supply and selected additional functions.
Fault displays
E:17
– Tap turned on?
– Water inlet hose kinked or jammed?
– Filter blocked? Clean filter aPage 10
– Water pressure too low?
E:18
– Loose debris is blocking the pump, clean the pump aPage 10
– Drainage hose blocked?
Other displays
Switch off the appliance, wait 5 seconds and switch it back on.
If the display appears again, call customer service.
To Next Page
Loading...
